![background image](http://html2.mh-extra.com/html/macdon/pw8/pw8_operators-manual_3429414057.webp)
214657
43
Revision A
Figure 3.22: Header on Combine
2.
Drive combine slowly up to header until feeder house
saddle (A) is directly under the header top beam (B).
3.
Raise feeder house slightly to lift header ensuring
feeder house saddle (A) is properly engaged in
header frame.
4.
Stop engine, and remove key from ignition.
Figure 3.23: Engaging Locks
5.
Lift lever (A) on header at left side of feeder house and
push handle (B) on combine to engage locks (C) on
both sides of the feeder house.
6.
Push down on lever (A) so that slot in lever engages
handle (B) to lock handle in place.
7.
If locks (C) do not fully engage the spacer tube and bolt
on the header, loosen nut (E) and adjust position of the
spacer tube and bolt (D) as necessary (both sides).
Tighten nut.
8.
Loosen bolts (F) and adjust lock as required to obtain
full lock on spacer tube and bolt (D) when lift lever (A)
and handle (B) are engaged. Retighten bolts.
Summary of Contents for PW8
