214657
99
Revision A
Figure 4.7: Header Height System Access Panel
–
Right Side
3.
Locate access panel on inside of right end frame.
Remove two bolts (A) from access panel (B).
4.
Remove access panel (B).
Figure 4.8: Header Height Sensor Assembly
–
Right Side
5.
Disconnect wire harness (A).
6.
Push up on rod end clip (B). Slide linkage rod (C) out of
rod end clip (B).
Figure 4.9: Header Height Sensor Assembly
–
Right Side
7.
Remove nuts and bolts (A).
8.
Remove sensor (B) and control arm (C).
NOTE:
Note orientation of control arm, this will be required for
reassembly.
Summary of Contents for PW8
