214657
83
Revision A
Figure 3.110: Left Side Spring Float Assembly
Shown
–
Right Side Opposite
5.
Check that all spring tension is released from the spring
float assembly (A). Remove cotter pin (B), clevis
pin (C), and three flat washers (D).
NOTE:
When spring tension is fully released, spring coils
should be fully collapsed and the spring float assembly
should rock from side to side when moved by hand. If
pressure on the clevis pin persists, slightly raise or
lower the header.
Figure 3.111: Left Side Anchor Shown
–
Right
Side Opposite
6.
Move spring float assembly (A) to float anchor holes (B)
to make wheel ground pressure lighter, or move spring
float assembly to float anchor hole (C) to make wheel
ground pressure heavier.
IMPORTANT:
The left and right spring float assemblies must be set to
the same anchor hole position or draper deck damage
could result.
NOTE:
If the spring float assembly (A) hole does not align with
float anchor holes (B) and (C), raise or lower header as
necessary.
Figure 3.112: Left Side Spring Float Assembly
Shown
–
Right Side Opposite
7.
Insert clevis pin (A) from the inboard side through the
rod end of spring float assembly (B), three flat
washers (C), and anchor (D) as shown. Secure with
cotter pin (E).
8.
Repeat procedure for opposite side of header, ensuring
that left and right spring float assemblies are set to the
same anchor hole position on header.
9.
Close left endshield. For instructions, refer to
Closing Left Endshield, page 30
.
10. Replace right endshield if previously removed.
Summary of Contents for PW8
