214657
206
Revision A
5.7
Decks
5.7.1
Draper Belts
Periodically check the draper belts for signs of wear and damage. Replace drapers that have stretched, have cuts
or tears, or have worn slats. Replace missing or damaged fasteners, damaged connector bars, and damaged
straps.
Removing Front Draper Belt
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine
and remove key before leaving the operator
’
s seat, and always engage safety props before going under
the machine for any reason.
1.
Raise the hold-down fully and engage lift cylinder safety props. Refer to
3.5 Engaging Hold-Down Lift Cylinder
2.
Raise the header fully, and engage the combine lift cylinder safety props.
3.
Stop the engine and remove the key from the ignition.
4.
Release draper belt tension fully. Refer to
Adjusting Front Draper Belt Tension, page 88
.
Figure 5.89: End Draper Belt
5.
Remove seven M6 flange nuts (A), belt edge
protector (B), and pronged elevator bolts (C) from
belt (D) (if removing end belt).
Figure 5.90: Front Draper Belt
6.
Remove M6 flange nuts (A), connector bar (B), and
pronged elevator bolts (C) from belt (D).
Summary of Contents for PW8
