MacDon PW8, Operator'S Manual

Page: 239 / 304

214657
225
Revision A
Figure 5.134: Right Side Rear Deck Idler Roller
6. Loosen the locking collar (A) and the three nuts (B)
attaching the bearing flange to the frame on the right
side of the header.
7. Loosen locking bolt (C).
Figure 5.135: Left Side Rear Deck Shown
–
Right Side Opposite
8. Turn adjuster nut (A) and draw the rear draper deck
roller assembly into the header until the leading edge of
the bearing support plate (B) lines up with the middle of
the single cutout (C) on each side of the header.
Figure 5.136: Left Side Rear Deck Shown
–
Right Side Opposite
9. Measure from the center of the rear drive roller to the
center of the front driven roller. Set dimension (A) to
490 mm (19-5/16 in.) on each side of the header.
MAINTENANCE AND SERVICING