214657
98
Revision A
Installing Header Height Sensor Assembly (Left Side)
Figure 4.5: Header Height Sensor Assembly
–
Left Side
1.
Install control arm (C). Ensure that flat side is facing
towards header.
2.
Install sensor (B), center bolts in slots, and secure with
nuts (A).
Figure 4.6: Header Height Sensor Assembly
–
Left Side
3.
Slide linkage rod (C) into rod end clip (B). Secure rod
end clip by pressing it onto linkage rod (C).
4.
Connect wire harness (A).
5.
Close left endshield. Refer to
.
Removing Header Height Control System (Right Side)
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
1.
Raise hold-down and engage lift cylinder safety props.
2.
Lower header to ground, shut down combine, and remove key from ignition.
Summary of Contents for PW8
