214657
159
Revision A
Figure 4.133: New Holland Combine Display
4.
Follow calibration steps in the order they appear on
screen. As you proceed through calibration process,
display will automatically update to show next step.
NOTE:
Pressing ESC key during programming or letting
system sit idle for more than three minutes will cause
calibration procedure to stop.
NOTE:
Refer to your combine operator
’
s manual for an
explanation of any error codes.
Figure 4.134: New Holland Combine Display
5.
When all steps have been completed, CALIBRATION
COMPLETED message is displayed on screen.
NOTE:
If float was set heavier to complete ground calibration
procedure, adjust to recommended operating float after
calibration is complete.
Setting Auto Height (New Holland CR Series)
This procedure applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90).
Figure 4.135: New Holland Combine Controls
The console has two buttons used for auto height presets.
The toggle switch that was present on previous models is
now configured as shown at right. MacDon headers only
require first two buttons (A) and (B). The third button (C) is
not configured.
To set auto height, follow these steps:
Summary of Contents for PW8
