MacDon PW8, Operator'S Manual

Page: 47 / 304

214657
33
Revision A
Figure 3.11: Attaching Support
5. Open the endshield (C) slightly so the support (B) can
be installed onto endshield. Check that washer (D) is
between the support and the endshield.
6. Install nut (A), leaving a gap of 8
–
10 mm (5/16
–
3/8 in.)
between the nut and washer (D), which allows
support (B) to move.
Figure 3.12: Endshield Support
7. Move endshield (A) slightly so support (B) can be
moved out of the locked position.
Figure 3.13: Endshield Closed
8. Close endshield (D) and use a slotted screwdriver to
turn latch (A) clockwise until it stops (slightly more than
one-half turn).
NOTE:
When latch is fully engaged, the slot will align with
notch (C), and the endshield will draw tightly against the
header.
9. Check that magnet (B) on endshield is against the
header endsheet and aligned with the cutout in the
frame, and that latch (A) is engaged.
OPERATION