214657
110
Revision A
Calibrating Auto Header Height Control (Case IH 5130/6130/7130, 5140/6140/7140)
NOTE:
This procedure applies to combines with a software version below 28.00. For instructions on calibrating the AHHC
for combines with software version 28.00 or above, refer to
Calibrating Auto Header Height Control (Case
Combines with Version 28.00 or Higher Software), page 118
NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator
’
s manual for updates.
Figure 4.34: Calibrating Auto Header Height
1.
Ensure all header electrical and hydraulic connections
are made.
2.
Lower the combine feeder house all the way down (the
feeder house will stop moving).
3.
Hold the DOWN button for 2 seconds.
4.
Push the RAISE button and hold it until the feeder
house travels all the way up. It will stop 61 cm (2 feet)
above ground for 5 seconds, then it will resume lift. This
is an indication that calibration is successful.
Setting Preset Cutting Height (Case 5130/6130/7130, 5140/6140/7140)
To set preset cutting height, follow these steps:
NOTE:
Changes may have been made to combine controls or display since this document was published. Refer to
combine operator
’
s manual for updates.
CAUTION
Check to be sure all bystanders have cleared the area.
Figure 4.35: Case Combine Console
1.
Engage separator and header.
2.
Manually raise or lower header to desired cutting
height.
3.
Press 1 on button (A). A yellow light next to the button
will illuminate.
Summary of Contents for PW8
