MacDon PW8, Operator'S Manual

Page: 101 / 304

214657
87
Revision A
3.12.7 Draper Belt Tension
The pick-up draper belt tension is set at the factory but should be checked before operating.
NOTE:
•
There should be visible sag in the underside of the draper.
•
Draper tension needs to be set only to prevent slippage.
•
Drapers may be sticky when new. Talcum or baby powder applied to the drapers should help reduce stickiness.
Checking Draper Belt Tension
DANGER
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator
’
s seat for any reason.
NOTE:
Drapers may be sticky when new. Talcum or baby powder applied to the drapers should help reduce stickiness.
1. Raise the header fully and engage the combine safety props.
2. Stop engine and remove key from ignition.
Figure 3.117: Draper Tension Indicator
3. Ensure drapers are visible through slots (A). Proper
tension is achieved when the draper aligns with
indicator notch in slots (A).
IMPORTANT:
For proper draper tracking, ensure deck indicator (B) is
in the same position on both sides of the header.
If adjustment is required, refer to Adjusting Front Draper
Belt Tension, page 88 or Adjusting Rear Draper Belt
Tension, page 90 .
OPERATION