214657
233
Revision A
Figure 5.154: Left Side Front Deck
–
Right
Side Opposite
8.
Turn adjuster nut (A) and draw the front draper deck
roller assembly into the header until the edge of the
header frame lines up with the middle of the second
slot (C) above the draper tension indicator cutout.
9.
Tighten the three clamp bolts (B) on each side of the
header.
Figure 5.155: Left Side Front Deck
–
Right
Side Opposite
10. Measure from the center of the rear drive roller to the
center of the front driven roller. Set dimension (A) to
490 mm (19-5/16 in.) on each side of the header.
11. If unable to achieve 490 mm (19-5/16 in.) for
dimension (A) with the frame in the middle of the
second slot, adjust the frame as necessary to achieve
correct measurement.
Summary of Contents for PW8
