214657
189
Revision A
Installing Auger Drive Chain
Figure 5.47: Auger Drive Chain
1.
Install chain (A) onto driven sprocket (B) and then onto
drive sprocket (C).
2.
Tighten chain. Refer to
3.
Apply a liberal amount of SAE 30 engine oil to the
chain (A).
4.
Close left endshield. Refer to
.
Adjusting Auger Drive Chain Tension
To adjust the tension of the auger drive chain, follow these steps:
Figure 5.48: Auger Drive Chain
1.
Loosen the two M16 hex flange nuts (A).
2.
To access tensioner bolt (B), remove the plug from the
access hole in the endsheet.
3.
Turn tensioner bolt (B) to adjust the chain tension.
Figure 5.49: Chain Deflection
4.
Rotate chain until the tightest point is at the mid-span,
and ensure there is 11
–
15 mm (7/16
–
9/16 in.) of
deflection (A) when a force of 44.5 N (10 lbf) is applied
at the midspan.
Summary of Contents for PW8
