214657
237
Revision A
Figure 5.161: Left Side Spring Float Assembly
Shown
–
Right Side Opposite
5.
Ensure all spring tension is released from the spring
float assembly (A), remove cotter pin (B), clevis pin (C),
and three flat washers (D).
NOTE:
When spring tension is fully released, spring coils
should be fully collapsed and the spring float assembly
should rock from side to side when moved by hand. If
pressure on the clevis pin persists, slightly raise or
lower the header.
Figure 5.162: Left Side Front Anchor Shown
–
Right Side Opposite
IMPORTANT:
Note the spring float assembly position on the anchor,
and ensure the left and right assemblies are set to the
same anchor hole position during installation or draper
deck damage could result.
7.
Remove cotter pin (B), clevis pin (C), and three flat
washers (D) from spring float assembly (A) at
front anchor.
8.
Remove spring float assembly (A).
Summary of Contents for PW8
