MacDon PW8, Operator'S Manual

Page: 222 / 304

214657
208
Revision A
Figure 5.94: Front Draper Belt
5. Install connector bars (A) onto bolts, and secure with
M6 flange nuts (B).
6. Torque M6 flange nuts (B) to 4
–
5.6 Nm (37
–
50 lbf
∙
in).
Figure 5.95: Front Draper Belt
7. Connect draper belt by installing M6 x 16 square neck
elevator bolts (A) at center locations, and M6 x 23
square neck elevator bolts (B) at finger (D) locations.
8. Install straps (C) and fingers (D) onto bolts, and secure
with M6 flange nuts (E).
9. Torque M6 flange nuts (E) to 4
–
5.6 Nm (37
–
50 lbf
∙
in).
10. Tension draper belts. Refer to Adjusting Front Draper
Belt Tension, page 88 .
Removing Rear Draper Belt
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine
and remove key before leaving the operator
’
s seat, and always engage safety props before going under
the machine for any reason.
1. Raise the hold-down fully and engage lift cylinder safety props. Refer to 3.5 Engaging Hold-Down Lift Cylinder
Safety Props, page 37 .
2. Raise the header fully, and engage the combine lift cylinder safety props.
3. Stop the engine and remove the key from the ignition.
4. Release draper belt tension fully. Refer to Adjusting Rear Draper Belt Tension, page 90 .
MAINTENANCE AND SERVICING