Kubota M9540, Workshop Manual

Page: 612 / 619

10-S48
M8540, M9540, WSM CABIN
(4) Removing Air Conditioner Pipes
Discharging Refrigerant Gas
1. Refer to “(1) Discharging the Refrigerant” in this section.
W1033151
Cover and Guide
1. Remove the both side panel guides (3).
2. Remove the both side panels (2).
3. Remove the both side covers (1).
W1033208
High Pressure Pipe 1, 2 and Low Pressure Pipe
1. Disconnect the low pressure pipe (3) and high pressure pipe 1 (1)
from the compressor (2), then cap the open fittings immediately
to keep moisture out of the system.
2. Slide the condenser (4).
3. Disconnect the high pressure pipe 1 (1) from the condenser (4)
and cap the open fittings immediately to keep moisture out of the
system.
4. Disconnect the high pressure pipe 2 (6) from the receiver (5) and
cap the open fittings immediately to keep moisture out of the
system.
(When reassembling)
• Apply compressor oil (DENSO CO. ND-OIL8) to the O-rings and
take care not to damage them.
W1033365
Seat, Mats and Floor Cover
1. Refer to “(3) Removing Air Conditioner Unit” in this section.
W1033832
Air Conditioner Ducts and Covers
1. Refer to “(3) Removing Air Conditioner Unit” in this section.
W1033899
(1) Side Cover
(2) Side Panel (3) Side Panel Guide
Tightening torque
Low pressure pipe
mounting screw
(compressor side) 7.9 to 11.8 N·m
0.8 to 1.2 kgf·m
5.8 to 8.7 lbf·ft
High pressure pipe 1
mounting screw
(compressor side) 7.9 to 11.8 N·m
0.8 to 1.2 kgf·m
5.8 to 8.7 lbf·ft
High pressure pipe 1
mounting screw
(condenser side) 7.9 to 11.8 N·m
0.8 to 1.2 kgf·m
5.8 to 8.7 lbf·ft
High pressure pipe 2
retaining nut
(receiver side) 11.8 to 14.7 N·m
1.2 to 1.5 kgf·m
8.7 to 10.8 lbf·ft
(1) High Pressure Pipe 1
(2) Compressor
(3) Low Pressure Pipe (4) Condenser
(5) Receiver
(6) High Pressure Pipe 2
KiSC issued 09, 2008 A