Kubota M9540, Workshop Manual

Page: 607 / 619

10-S43
M8540, M9540, WSM CABIN
(2) Removing Compressor Assembly
Compressor Assembly
1. Discharge the refrigerant from the system. (Refer to “(1)
Discharging the Refrigerant” in this section.)
2. Disconnect the low pressure pipe (suction) (1) and high pressure
pipe 1 (discharge) (2) from the compressor, then cap the open
fitting immediately to keep moisture out of the system.
3. Disconnect the 1P connector (3) of magnetic clutch.
4. Remove the air conditioner belt (5) and remove the compressor
(4) with stay.
(When reassembling)
• After reassembling the compressor, be sure to adjust the air
conditioner belt tension and recharge the refrigerant to the
system. (Refer to “(3) Charging the Refrigerant” in this section.)
• Apply compressor oil (DENSO CO. ND-OIL8 or equivalent) to
the O-rings and take care not to damage them.
• “S” letter is marked on the compressor for connecting the low
pressure pipe (suction side).
• “D” letter is marked on the compressor for connecting the high
pressure pipe (discharge side).
• When replacing the compressor with a new one, meet the oil
amount with old one.
• Push on the belt between the pulleys with a finger. Deflection ( L )
of 10 to 12 mm (0.4 to 0.48 in.) under a 98 N (10 kgf, 22 lbf) load
is appropriate.
W1014469
Tightening torque
High pressure pipe 1 and
low pressure pipe
mounting screw 7.9 to 11.8 N·m
0.8 to 1.2 kgf·m
5.8 to 8.7 lbf·ft
Compressor mounting
screws
24.5 to 29.4 N·m
2.5 to 3.0 kgf·m
18.1 to 21.7 lbf·ft
(1) Low Pressure Pipe
(2) High Pressure Pipe 1
(3)
1P Connector (Magnetic Clutch)
(4) Compressor
(5) Air Conditioner Belt
(6) New Compressor
(7) Old Compressor
(8) Remove the Excess Oil (
A - B )
(9) Lock Nut
(10) Adjusting Bolt
A : Oil Flow New Compressor
B : Oil Flow Replace Compressor
L : Deflection (10 to 12 mm
(0.4 to 0.48 in.))
KiSC issued 09, 2008 A