Kubota M9540, Workshop Manual

Page: 50 / 619

G-31
M8540, M9540, WSM G GENERAL
Checking Air Conditioner Condenser (CABIN Model)
1. Release the air conditioner hoses off the hook (1).
2. Loosen the wing nut (2).
3. Hold the handle (3), slide out the air conditioner condenser (7).
4. Check air conditioner condenser (7) and air conditioner
condenser screen (6) to be sure it is clean of debris.
CAUTION
• Be sure to stop the engine before removing the screen.
• The condenser and receiver become hot while the air
conditioner is running. Before checking or cleaning them,
wait long enough until they cool down.
IMPORTANT
Q
• Do not hold the air conditioner receiver or the air conditioner
pipes when sliding out the condenser for cleaning.
W1019699
Adjusting Air Conditioner Belt Tension (CABIN Model)
CAUTION
• Be sure to stop the engine before checking belt tension.
1. Push on the belt between the pulleys with a finger under 9.8 N
(10 kgf, 22 lbf) load is appropriate.
2. If tension is incorrect, loosen the tension pulley mounting nut (1)
and turn the adjusting screw (2) to adjust the belt tension within
acceptable limits.
W1104407
[6] CHECK POINTS OF EVERY 300 HOURS
Replacing Hydraulic Oil Filter
1. Refer to “[2] CHECK POINTS OF INITIAL 50 HOURS” in this
section.
W1072600
Changing Engine Oil
1. Refer to “[2] CHECK POINTS OF INITIAL 50 HOURS” in this
section.
W1071704
(1) Hook
(2) Wing Nut
(3) Handle
(4) Receiver (5) Air Condenser Hose
(6) Air Conditioner Condenser Screen
(7) Air Conditioner Condenser
Belt tension ( L ) Factory spec.
10 to 12 mm
0.40 to 0.47 in.
(1) Tension Pulley Mounting Nut
(2) Adjusting Screw L : Belt Tension
KiSC issued 09, 2008 A