Kubota M9540, Workshop Manual

Page: 52 / 619

G-33
M8540, M9540, WSM G GENERAL
[8] CHECK POINTS OF EVERY 600 HOURS
Replacing Engine Oil Filter
1. Refer to “[2] CHECK POINTS OF INITIAL 50 HOURS” in this
section.
W1074023
Changing Transmission Fluid
1. Refer to “[2] CHECK POINTS OF INITIAL 50 HOURS” in this
section.
W1074077
Changing Front Differential Case Oil
1. Refer to “[2] CHECK POINTS OF INITIAL 50 HOURS” in this
section.
W1074134
Changing Front Axle Gear Case Oil
1. Refer to “[2] CHECK POINTS OF INITIAL 50 HOURS” in this
section.
W1074346
Adjusting Front Axle Pivot
1. If the front axle pivot pin adjustment is not correct, front wheel
vibration can occur causing vibration in the steering wheel.
Q
Adjusting Procedure
1. Loosen the lock nut (2), screw in the adjusting screw (1) until
seated, then tighten the screw (1) with an additional 1/6 turn.
Retighten the lock nut (2).
W1027783
[9] CHECK POINT OF EVERY 800 HOURS
Adjusting Engine Valve Clearance
1. Refer to “[1] CHECKING AND ADJUSTING” at “1. ENGINE”
section.
W1027950
[10] CHECK POINT OF EVERY 1500 HOURS
Checking Fuel Injection Nozzle (Injection Pressure)
1. Refer to “[1] CHECKING AND ADJUSTING” at “1. ENGINE”
section.
W1075043
Tightening torque Lock nut
98.1 to 147.1 N·m
10.0 to 15.0 kgf·m
72.3 to 108.5 lbf·ft
(1) Adjusting Screw (2) Lock Nut
KiSC issued 09, 2008 A