Kubota M9540, Workshop Manual

Page: 267 / 619

3-S23
M8540, M9540, WSM TRANSMISSION
Steering Support Under Cover and Rear Bonnet
1. Remove the steering support under cover (1).
2. Remove the rubber sheet (3) and disconnect the
3-1P
connectors (2).
3. Remove the shield assembly (6).
4. Loosen the rear bonnet mounting screws (8).
5. Remove the seal (4) and panel guide mounting screw (5).
6. Disconnect the wire harness and remove the rear bonnet (7).
W1018688
Separating Engine from Clutch Housing
1. Make sure the engine and clutch housing case are securely
mounted on the disassembling stands.
2. Remove the steering support mounting screw (1) for front side.
3. Remove the engine mounting screws and nut, and separate the
engine from the clutch housing.
(When reassembling)
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the splines of damper disc boss.
• Apply liquid gasket (Three Bond 1141, 1211 or equivalent) to joint
face of the engine and clutch housing.
W1013389
(2) CABIN Model
Side Panel
1. Remove the both side cover guides (3).
2. Remove the both side panels (1).
3. Remove the air cleaner hose (2).
W1022025
(1) Steering Support Under Cover
(2)
1P Connectors
(3) Rubber Sheet
(4) Seal
(5) Screw
(6) Shield
(7) Rear Bonnet
(8) Screw
Tightening torque
Engine and clutch housing
mounting screw and nut
(M14, 7T) 124 to 147 N·m
12.6 to 15.0 kgf·m
91.2 to 108 lbf·ft
Engine and clutch housing
mounting stud bolt
61.8 to 73.6 N·m
6.3 to 7.5 kgf·m
45.6 to 54.2 lbf·ft
(1) Steering Support Mounting Screw
(1) Side Panel
(2) Air Cleaner Hose (3) Side Cover Guide
KiSC issued 09, 2008 A