Kubota M9540, Workshop Manual

Page: 601 / 619

10-S37
M8540, M9540, WSM CABIN
Preparation 3 (Continued)
1. Remove the compressor (1) with hoses and compressor bracket.
(When reassembling)
• Take care not damage the air condenser fin.
• After reassembling the compressor, be sure to adjust the air
conditioner belt tension.
(Refer to “7. CHECK AND MAINTENANCE” at “G. GENERAL”
section.)
Q
With discharge the refrigerant from system
1. Refer to “(1) Discharging the Refrigerant” in this section.
2. Disconnect the low pressure pipe (2) and high pressure pipe 1 (3)
from compressor (1).
(When reassembling)
• Charge the refrigerator to the air conditioner system, refer to “(3)
Charging the Refrigerant” in this section.
• Apply compressor oil (DENSO CO. ND-OIL8) to the O-rings and
take care not to damage them.
W1052713
Tightening torque
Compressor bracket
mounting screw (M8) to
aluminum parts 17.7 to 20.5 N·m
1.8 to 2.1 kgf·m
13.1 to 15.1 lbf·ft
Compressor bracket
mounting screw (M8) to
ordinariness parts 23.6 to 27.4 N·m
2.4 to 2.8 kgf·m
17.4 to 20.2 lbf·ft
Compressor bracket
mounting screw (M10) to
ordinariness parts 48.1 to 55.8 N·m
4.9 to 5.7 kgf·m
35.5 to 41.2 lbf·ft
Tightening torque
High pressure pipe 1
mounting screw
7.9 to 11.8 N·m
0.8 to 1.2 kgf·m
5.8 to 8.7 lbf·ft
Low pressure pipe
mounting screw
7.9 to 11.8 N·m
0.8 to 1.2 kgf·m
5.8 to 8.7 lbf·ft
(1) Compressor
(2) Low Pressure Hose (3) High Pressure Hose 1
KiSC issued 09, 2008 A