Kubota M9540, Workshop Manual, Page: 269 / 619

3-S25
M8540, M9540, WSM TRANSMISSION
Preparation 3 (Continued)
1. Remove the compressor (1) with hoses and compressor bracket.
(When reassembling)
• Take care not damage the air condenser fin.
• After reassembling the compressor, be sure to adjust the air
conditioner belt tension.
(Refer to “7. CHECK AND MAINTENANCE” at “G. GENERAL”
section.)
W1052713
Accelerator Wire, Fuel Hose, Heater Hose and Wire Harness
1. Remove the hose clamps (6).
2. Disconnect the heater hoses (4).
3. Disconnect the accelerator wire (1).
4. Disconnect the master cylinder hose (12).
5. Remove the bonnet support (11).
6. Remove the fuel hose (2) and (7).
7. Remove the retaining nut for hydraulic pipe (8).
8. Remove the connectors for air heater (3), engine speed sensor
(5) and engine stop solenoid (9).
(When reassembling)
• Be sure to fix the heater hose to the original position. Note the
inlet hose and outlet hoses.
W1022765
Tightening torque
Compressor bracket
mounting screw (M8) to
aluminum parts 17.7 to 20.5 N·m
1.8 to 2.1 kgf·m
13.1 to 15.1 lbf·ft
Compressor bracket
mounting screw (M8) to
ordinariness parts 23.6 to 27.4 N·m
2.4 to 2.8 kgf·m
17.4 to 20.2 lbf·ft
Compressor bracket
mounting screw (M10) to
ordinariness parts 48.1 to 55.8 N·m
4.9 to 5.7 kgf·m
35.5 to 41.2 lbf·ft
(1) Compressor (2) Condenser
Tightening torque Master cylinder hose nut
22.6 to 27.5 N·m
2.3 to 2.8 kgf·m
16.6 to 20.3 lbf·ft
(1) Accelerator Wire
(2) Fuel Hose
(3) Air Heater
(4) Heater Hose
(5) Engine Speed Sensor
(6) Hose Clamp (7) Fuel Hose (Overflow)
(8) Hydraulic Pipe
(9) Engine Stop Solenoid
(10) Master Cylinder Return Hose
(11) Bonnet Support
(12) Master Cylinder Hose
KiSC issued 09, 2008 A