Kubota M9540, Workshop Manual, Page: 181 / 619

1-S58
M8540, M9540, WSM ENGINE
(6) Piston and Connecting Rod
Oil Pan and Oil Strainer
1. Unscrew the oil pan mounting screws and remove the oil pan (1).
2. Unscrew the oil strainer mounting screw, and remove the oil
strainer (2).
(When reassembling)
• Install the oil strainer, using care not to damage the O-ring.
• Apply liquid gasket (Three Bond 1217D or equivalent) to the oil
pan as shown in the figure.
• Confirm that the liquid gasket coating surface is free of water,
dust and oil in order to maintain sealing effect.
• Carefully apply the adhesive evenly.
NOTE
Q
• When mounting the adhesive-applied parts, take care to fit
them to the mating parts.
• Assemble the adhesive-applied parts within ten minutes.
• To avoid uneven tightening, tighten mounting screws in
diagonal order from the center.
• After cleaning the oil strainer, install it.
• Attach the oil pan with its central drain plug facing toward
the air suction side.
W1054035
Tightening torque
Oil pan mounting screw
(
A )
L : 165 mm (6.5 in.)
74 to 78 N·m
7.5 to 8.0 kgf·m
55 to 57 lbf·ft
Oil pan mounting screw
(
B )
L : 25 mm (1.0 in.)
49 to 55 N·m
5.0 to 5.7 kgf·m
37 to 41 lbf·ft
(1) Oil Pan
(2) Oil Strainer
(3) Liquid Gasket (A) Oil Pan Mounting Screw :
165 mm (6.5 in.)
(B) Oil Pan Mounting Screw :
25 mm (1.0 in.)
KiSC issued 09, 2008 A