Korg MMT RADIAS, Owner'S Manual, Page: 93 / 176

3. Synth Parameters
87
THRU
The sound will output directly, without passing
through the filter.
3: Cutoff (Cutoff Frequency)

CUTOFF

[000…127]
Specifies the cutoff frequency. Higher settings will raise
the cutoff frequency.
“Cutoff” can be modified by the time-varying
changes produced by EG1, position of the notes on
the keyboard (keyboard tracking), or keyboard
dynamics (velocity). The “EG 1 Int,” “Key Track,”
and “Velo Sens” parameters specify the degree to
which these will affect “Cutoff.”
With some “Cutoff” settings, the volume may be
extremely low or there may be no sound at all.
4: Resonance

RESONANCE

[000…127]
Specifies the resonance. This boosts the region near the
“Cutoff” frequency, giving a distinctive character to the
sound. Increasing this value will produce a greater ef-
fect.
High settings of “Resonance” may cause distor-
tion for some cutoff frequencies or input sounds.
5: EG1 Int (EG1 Intensity)

EG 1 INT

[–63…+63]
Specifies the degree to which EG 1 will modulate the
cutoff frequency. This will cause the cutoff frequency to
change over time. Increasingly positive (+) values will
produce a greater effect.
Increasingly negative (–) values will produce a greater
effect in the opposite direction.
6: KeyTrack (Keyboard Track)

KEY TRACK

[–2.00…+2.00]
Specifies how keyboard tracking (location on the key-
board) will modulate the cutoff frequency.
With a setting of 0, keyboard tracking will have no ef-
fect. Positive (+) settings will cause the cutoff frequency
to rise as you play above the C4 key, or fall as you play
below the C4 key. With a setting of +1.0, the change in
cutoff frequency will be proportional to the change in
pitch. Negative (–) settings will cause the cutoff frequen-
cy to fall as you play above the C4 key, or rise as you
play below the C4 key.
Keyboard tracking is based on the pitch as con-
trolled by pitch bend, transpose, and modulation
sequencer. It does not reflect pitch changes pro-
duced by vibrato or virtual patching.
7: VeloSens (Velocity Sens) [–63…+63]
Specifies how velocity (keyboard playing dynamics)
will affect the cutoff frequency.
Positive (+) values will cause the cutoff frequency to rise
as you play more strongly.
Negative (–) values will cause the cutoff frequency to
fall as you play more strongly.
P07–2: FILTER2
These are the parameters for filter 2.
These parameters are available if FILTER1 “Routing” is
Serial, Para, or Indiv.
1: LinkSw [Off, On]
Causes filter 2 to operate using the settings of filter 1 pa-
rameters.
Off
Filter 1 and filter 2 parameters can be set independently.
On
Filter 2 will operate using the settings of the filter 1 pa-
rameters. Parameters following “Cutoff” will use the fil-
ter 1 settings.
HPF (High Pass Filter)
Cutoff
Frequency
The effect of resonance
LPF
HPF
BPF
Low resonance setting High resonance setting
Note on
Note off
Note on
Note off
Cutoff
Int=+32
Int=0
Int=+63
Time
Cutoff frequency
specified by
“Cutoff”
Note on
Note off
Note on
Note off
Cutoff
Int=–32
Int=0
Int=–63
Time
Cutoff frequency
specified by
“Cutoff”