Korg MMT RADIAS, Owner'S Manual, Page: 107 / 176

5. Step Sequencer
101
Trigger
Indicates the “Trigger” setting (
☞
p.102 “Trigger”).
is shown for steps whose “Trigger” is on, and – for
steps whose “Trigger” is off.
Drum01…Drum16
Specifies a drum instrument. This is valid if the timbre is
using a drum kit. The indication is shown for steps
that sound the specified drum instrument.
If the “Trigger” setting (
☞
p.102 “Trigger”) is –, the
– indication is shown even for steps that sound the
specified drum instrument.
C-1…G9
Specifies a note number. The indication is shown for
steps that sound the specified drum instrument.
If the “Trigger” setting (
☞
p.102 “Trigger”) is –, the
– indication is shown even for steps that sound the
specified note number.
2: Step On/Off [–, o]
Turns each step on/off.
Use the cursor buttons to move to the on/off indication,
and use the [PROGRAM/VALUE] dial to turn it on or
off.
P15–3: STEP (STEP SEQ1 Step)
Here you can edit each step of the data recorded in the
step sequencer. This is a convenient way to edit record-
ed data.
1: Step [01…64]
Selects the step number to edit.
The maximum step number you can select here is deter-
mined by the “LastStep” parameter.
2: GateTime [001…099, TIE]
Specifies the duration (gate time) of the note sounded by
each step.
Higher values produce a longer duration. If you set this
to TIE, the note will sound until the next step.
Notes within the same step will all have the same
gate time regardless of their note number.
3: Velocity [001…127, KEY]
Specifies the velocity for the note(s) sounded by each
step.
With a setting of 1–127, the notes will always sound with
the specified velocity value. With a setting of Key, the
notes will sound with the velocity of the note you played
to start the step sequencer.
Notes within the same step will all have the same
velocity regardless of their note number.
4: Trigger [–, o]
Turns each step on/off.
Steps set to will sound.
Steps set to – will not sound.
If you change a – step to , the note numbers previously
assigned to that step will be assigned.
In the case of a step to which no notes had previously
been assigned, note numbers will be assigned according
to the following rules.
• If the timbre to which the step sequencer is assigned
is using a drum kit, the DrumKit Inst=01 note num-
ber will be assigned.
• If the timbre to which the step sequencer is assigned
is not using a drum kit, the C4 note number will be
assigned.
5: Trigger Note 1...8 [C-1...G9, ---]
Specifies the note number that will be sounded by each
step. You can specify up to eight notes.
C-1–G9
The specified note number will be sounded.
---
No note will be sounded.
P15–4: COMN (STEP SEQ2 Common)
Here you can make settings for step sequencer 2. The
contents of the parameters are the same as for step se-
quencer 1.
If the P15–1: STEP SEQ1 – COMN tab page “S.Se-
qLink” setting is turned On to link the two step se-
quencers, you will use the P15: STEP SEQ1 page to
set the parameters for each step of step sequencer
2. The P15–4: COMN tab page and following will
indicate “No Selected,” and you will be unable to
set the parameters of step sequencer 2.
Note status
: will sound
– : will not sound
Step number