Korg MMT RADIAS, Owner'S Manual, Page: 125 / 176

4. Utility
119
1: ParamName (Parameter Name)
[Portament…VcdEFSens]
Select the knob or button.
2: CtrlChg# (Control Change No.)
[Off, 000…095, 102…119]
Assign a MIDI control change number (CC#) for the
knob or button selected in “ParamName.”
If the selected value is already assigned to another
parameter, an “*” is shown at the right of the val-
ue.
The MIDI channel for vocoder parameters will be
the same MIDI channel as the timbre that is select-
ed as the vocoder carrier (Vocoder Edit mode P06:
CARRIER page “InSrc1”).
P08 PEDAL/SW
P08–1: PEDAL/SW
1: A.Pedal (Assignable Pedal) [Volume…FootPedal]
Selects the function of the pedal connected to the AS-
SIGNABLE PEDAL jack. With the factory settings this is
set to ExpPedal.
Volume
The pedal will control the volume of the timbres used in
the program.
ExpPedal
The pedal will control the volume of the timbres used in
the program. The expression value is multiplied by the
volume value to specify the actual loudness.
Pan
The pedal will control the panning of the timbres used
in the program.
AftTouch
The pedal will control the aftertouch for timbres used in
the program.
ModWheel
The pedal will control the effect of the modulation
wheel.
BrthCtrl
The pedal will control the MIDI control change Breath
Control (CC#02).
FootPedal
The pedal will control the MIDI control change Foot
Control (CC#04).
2: A.SwFunc (Assignable Switch Function)
[Damper…FootSw]
Selects the function of the pedal switch connected to the
ASSIGNABLE SWITCH jack. With the factory settings
this is set to Damper.
Damper
The pedal switch will function as a damper pedal.
ProgUp, ProgDown
The pedal switch will increment or decrement the pro-
gram.
OctUp, OctDown
The pedal switch will change the octave. Turning the
switch on will shift the pitch by +1/–1 octave.
PortSw
The pedal switch will function as a portamento on/off
switch.
ArpStop
The pedal switch will start and reset the arpeggiator and
step sequencers.
FootSw
The pedal switch will control the parameter assigned to
FootSw as the control source for an effect, etc.
3: A.SwPol (Assignable Switch Polarity)
[– (KORG), +]
Specifies the polarity of the pedal switch connected to
the ASSIGNABLE SWITCH jack. With the factory set-
tings this is set to – (KORG).
Choose the – setting if you’re using a Korg PS-1
pedal switch, or if you’re not using any pedal
switch.
4: A.SwMode (Assignable Switch Mode)
[UnLatch, Latch]
Specifies the mode of on/off operation for the pedal
switch connected to the ASSIGNABLE SW jack. With
the factory settings this is set to UnLatch.
UnLatch
The assigned function will be on only while the pedal
switch is held down.
Latch
The assigned function will alternate between on and off
each time the switch is pressed.