Korg MMT RADIAS, Owner'S Manual, Page: 104 / 176

Program parameters
98
P14–2: TRIG (Arpeggiator Step On/Off)
Here you can turn individual steps of the arpeggio pat-
tern on/off. This is a way to add rhythmic variety to an
arpeggio pattern.
You can use the P16–5: UTILITY – ARP tab page
“CopyArpStep” function to copy the step on/off
settings from the arpeggiator of a different pro-
gram. (
☞
p.110 “CopyArpStep”)
The P14–2: ARPEGGIATOR – TRIG tab page shows the
on/off status of each step.
1: Trigger (Step On/Off) [–, o]
Turns each step 1–16 on or off.
This will be valid to the step specified by “LastStep” in
the P14–1: ARPEGGIATOR – COMN tab page.
– (Off)
The note(s) at this step will be muted.
o (On)
The note(s) at this step will play.
P14–3: STEP
(Arpeggiator Step Parameters)
Here you can specify the gate time (duration) and veloc-
ity of each note sounded by the arpeggiator. You can use
these settings to add rhythmic interest and a groove feel-
ing to an arpeggiator performance.
You can use the P16–5: UTILITY – ARP/STEP SEQ
UTILITY tab page “CopyArpStep” function to
copy the arpeggiator settings from another pro-
gram. (
☞
p.110 “CopyArpStep”)
The valid length (the cycle at which steps are re-
peated) for these settings is determined by the
P14–1: ARPEGGIATOR – COMN tab page “Last-
Step” parameter, in the same way as the valid
length for the on/off settings.
If you want the arpeggio pattern to be silent for a
specific step, make settings in the P14–2: ARPEG-
GIATOR – TRIG tab page.
1: Step [01…32]
Selects the step to edit.
The maximum step number you can select here is deter-
mined by the P14–1: ARPEGGIATOR – COMN tab page
“LastStep” parameter.
2: GateTime [001…099, TIE]
Specifies the gate time for the step selected by “Step.”
Higher values produce a longer duration. If you set this
to TIE, the note will sound until the next note.
3: Velocity [001…127, KEY]
Specifies the velocity for the step selected by “Step.”
With a setting of 1–127, the step will always sound with
the specified velocity value. With a setting of Key, the
step will sound with the same velocity as the note you
played to start the arpeggiator.
4: Trigger [–, o]
Turns the note selected by “Step” on/off. This is the
same setting as the P14–2: ARPEGGIATOR – TRIG tab
page “Trigger” parameter.
Note status
: will sound
– : will not sound
Step number