Korg MMT RADIAS, Owner'S Manual, Page: 46 / 176

Editing
40
Creating time-varying change in the tone (EG1)
EG1 applies time-varying change to the cutoff frequency (the “Cutoff” of FILTER 1 or FILTER 2).
EG1 applies the same effect to filter 1 and filter 2.
You can edit the virtual patching so that EG1 will apply modulation to other parameters as well.
Envelope settings for tonal change
1
Use the EG 1 [ATTACK] knob to adjust the attack time (the time over which the tone changes
during the beginning of the note).
Turn the knob toward the right to make the tone change more slowly, or turn it toward the left to
make the tone change more quickly.
If turning this knob does not produce results, try adjusting the FILTER [EG 1 INT] knob or make
sure that the MOD SEQUENCER [SELECT] button is set to make EDIT lit. If an LED other than
EDIT is lit, you can’t edit the EG or LFO. (These knobs are used to edit the modulation sequencer
data.)
2
Use the EG 1 [DECAY] knob to adjust the decay time (the time over which the tone falls from
its peak).
Turning the knob toward the right (i.e., increasing the value) will make the tone change more
slowly until it reaches a stable tone (if sustained).
3
Use the EG 1 [SUSTAIN] knob to adjust the sustain level (the brightness during the sustain).
The brightness produced by the [SUSTAIN] knob will depend on the FILTER [EG 1] knob setting.
4
Use the EG 1 [RELEASE] knob to adjust the release time (the time over which the tone falls
after you release the key).
Turning the knob toward the right will produce a slower change in tone, and turning it toward the
left will make the tone change quickly.
a: Attack Time c: Sustain Level
b: Decay Time d: Release Time
Time
Note on
Note off
a
c
d
b