Korg MMT RADIAS, Owner'S Manual, Page: 87 / 176

3. Synth Parameters
81
This parameter is available if the unison “Sw” function
is On.
The “Detune” setting has no effect for OSC1 (oscil-
lator 1) if the P06–1: OSC1 “Wave (OSC1 Wave)” is
set to DrumPCM.
4: Spread [000…127]
Specifies how far the panning of the voices is spread
apart when using the Unison function. The panning of
each stacked voice will be spread by the amount you
specify here.
This parameter is available if the unison “Sw” function
is On.
P05 PITCH
These are the pitch-related parameters.
These parameter setting has no effect for OSC1
(oscillator 1) if the P06–1: OSC1 “Wave (OSC1
Wave)” is set to DrumPCM.
P05–1: PITCH
1: Transpose [–48…+48]
Shifts the pitch produced by the oscillators in steps of a
semitone (100 cents).
You can adjust this in a range of four octaves upward or
downward.
The front panel [OCTAVE] buttons shift the pitch
range assigned to the keyboard and the 16KEYS
[1]–[16] keys in steps of one octave; they do not
change the pitch of the sound you hear, nor is the
setting saved when you Write. Use this Transpose
setting when you want to change the pitch of the
oscillators themselves.
2: Tune [–50…+50 cent]
Adjusts the pitch produced by the oscillators in steps of
one cent.
You can adjust this in a range of –50 – +50 cents.
3: AnalgTun (Analog Tune) [000…127]
By adding a slight randomness to the pitch of each note
as it is played, this lets you simulate the pitch instability
and oscillator “drift” that was characteristic of analog
synthesizers. Higher settings will produce greater vari-
ations in pitch.
4: VibratInt (Vibrato Intensity)
[–2400…+2400cent]
Specifies the depth of the vibrato that will occur when
the modulation wheel is moved to its maximum posi-
tion.
LFO2 will apply vibrato to the pitch of the oscillators.
5: BendRange [–12…+12]
Specifies the amount of pitch change (in semitone units)
that can be produced by the pitch bender. This value
specifies the amount of pitch change that will occur
when the pitch bender is moved all the way in the posi-
tive (+) direction.
6: Portamnto (Portamento Time)

TIME

[000…127]
Specifies the portamento time.
Portamento is a function that creates a smooth transition
in pitch between one note and the next.
With a setting of 000 there will be no portamento. With
higher settings, it will take longer to reach the pitch of
the next note played.
7: PrtmCurve (Portamento Curve) [LogHard…Expo]
Specifies the curve used by the portamento effect.
P06 OSC/MIXER
These are the parameters that specify the algorithm,
waveform and output of each oscillator. The RADIAS
provides two oscillators for each timbre. You can use
these two oscillators to create a variety of complex
waveforms.
P06–1: OSC 1
First note-on
Second note-on
1: Expo
2: Linear
3: LogSoft
4: LogMid
5: LogHard
Time (=“Portamento Time”)
Pitch
1
2
3
4
5