Korg MMT RADIAS, Owner'S Manual, Page: 45 / 176

Program parameter editing
39
2
Use the FILTER 1 [CUTOFF] knob to adjust the cutoff frequency of filter 1.
Turning the knob toward the right (increasing the value) will make the sound brighter.
3
Use the FILTER 1 [RESONANCE] knob to adjust the resonance of filter 1.
Turning the knob toward the right (increasing the value) will boost the region near the cutoff fre-
quency.
The effect of resonance is also greatly affected by the filter type and cutoff frequency setting.
Depending on the cutoff frequency and the input sound, raising the resonance value may cause dis-
tortion.
4
Use the FILTER [SELECT] button to select FILTER 1, and use the [EG
1 INT] knob to adjust the depth of the effect that EG1 will have on
the cutoff frequency of filter 1.
If you turn the knob toward the right of the center position (“+” val-
ues), the EG will move the filter in the positive direction (i.e., if the fil-
ter type is LPF, the sound will become brighter).
If you turn the knob toward the left of the center position (“–” values),
the EG will move the filter in the negative direction (i.e., if the filter
type is LPF, the sound will become darker).
Filter 2 settings
1
Use the FILTER 2 [TYPE] button to select the type of filter being used
by filter 2.
The filter type will change each time you press the button, and the LED
of the selected filter type will light. The filter type will have a major
effect on the character of the sound.
If the FILTER 1 [ROUTING] button has been set to SINGLE, filter 2 is
not used and cannot be edited.
2
Use the FILTER 2 [CUTOFF] knob to adjust the cutoff frequency of
filter 2.
Turning the knob toward the right (increasing the value) will make the
sound brighter.
3
Use the FILTER 2 [RESONANCE] knob to adjust the resonance of
filter 2.
Turning the knob toward the right (increasing the value) will boost the
region near the cutoff frequency.
The effect of resonance is also greatly affected by the filter type and
cutoff frequency setting.
Depending on the cutoff frequency and the input sound, raising the res-
onance value may cause distortion.
4
Use the FILTER [SELECT] button to select FILTER 2, and use the [EG 1 INT] knob to adjust the
depth of the effect that EG1 will have on filter 2’s cutoff frequency.
If you turn the knob toward the right of the center position (“+” values), the EG will move the fil-
ter in the positive direction (i.e., if the filter type is LPF, the sound will become brighter).
If you turn the knob toward the left of the center position (“–” values), the EG will move the filter
in the negative direction (i.e., if the filter type is LPF, the sound will become darker).