Program parameters
94
If you set “Knob” to OSC1c2 (OSC1 Control 2)
when OSC1 “Wave” is set to Synth PCM or Drum
PCM, the operation will be the same as Step even
if this parameter is set to Smooth.
(Step)
The value recorded at each step will be held until the
next step plays.
3: StepSel (Step Select)
[01…Last Step]
Selects the step to edit.
4: Value (Step Value)
[–24…+24, –63…+63]
Edits the value recorded in the step specified by
“StepSel” of the modulation sequence.
The value specified here will be an offset applied to the
current value of the parameter that is assigned to the
modulation sequence. For example if the current value
is +10, and the sequence data co10, +10, +20…
starting at step 1, the resulting value of the parameter
will change as +20, +20, +30… when playback begins.
Use the cursor buttons to move the cursor to the step
you want to edit, and use the [PROGRAM/VALUE] dial
to edit the value. Alternatively, you can use the MOD
SEQUENCER [SELECT] button to select the modulation
sequence you want to edit, and use the sixteen knobs to
edit the values.
P13 EQ/FX (Equalizer/Effect)
Here you can edit the parameters for the equalizer and
effects.
P13–1: EQ
These are the equalizer settings.
The equalizer is used to adjust the tonal balance of each
timbre, for example by bringing out certain frequencies
that tend to be buried, or reducing other frequencies that
are too obtrusive. The equalizer is connected immedi-
ately after the timbre output.
1: HiFreq (High Frequency)
[1.00…20.0kHz]
Specifies the cutoff frequency of the high equalizer
(shelving type).
2: HiGain (High Gain)
HI
[–15.0…+15.0dB]
Specifies the gain of the high equalizer. Positive (+) set-
tings will boost the sound in the region of the cutoff fre-
quency, and negative (–) settings will cut the sound in
the region of the cutoff frequency.
3: LoFreq (Low Frequency)
[0020…1000Hz]
Specifies the cutoff frequency of the low equalizer
(shelving type).
4: LoGain (Low Gain)
LO
[–15.0…+15.0dB]
Specifies the gain of the low equalizer. Positive (+) set-
tings will boost the sound in the region of the cutoff fre-
quency, and negative (–) settings will cut the sound in
the region of the cutoff frequency.
Raising the gain excessively may cause the output
to distort.
P13–2, 3: IFX1, 2 (Insert Effect 1, 2)
These are the settings for insert effects 1 and 2.
Two insert effects (insert effect 1 and insert effect 2) are
provided for each timbre. After the output of a timbre
has passed through the EQ, it is connected in series
through effect 1 and then effect 2.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Steps
Summary of Contents for MMT RADIAS
