Korg MMT RADIAS, Owner'S Manual, Page: 44 / 176

Editing
38
Oscillator 2 settings
1
Use the OSCILLATOR 2 [WAVE] button to select the waveform of
oscillator 2.
The waveform will change each time you press the button, and the
LED of the selected waveform will light. You can choose one of four
different waveforms. The most common way to use this is to select the
same waveform as oscillator 1, and change its pitch slightly to create a
rich sound.
2
Use the OSCILLATOR 2 [OSC MOD] button to select the modula-
tion type for oscillator 2.
The type will switch each time you press the button, and the LED for
the selected modulation type will light. You can choose one of three
modulation types.
3
Use the [SEMITONE] knob to adjust the pitch of oscillator 2 in
semitone steps.
Some of the more common ways to set this parameter is to lower the
pitch by one octave (–12) or two octaves (–24) relative to the pitch of
oscillator 1. Vintage analog synthesizer players would sometimes set
the oscillators a fourth (+5) or fifth (+7) apart in pitch.
4
Use the [TUNE] knob to adjust the pitch of oscillator 2.
You can produce a richer sound by slightly changing the pitch to create a detuned effect.
Adjusting the volume of each oscillator
1
Use the MIXER [OSC 1] knob to adjust the volume of oscillator 1.
2
Use the MIXER [OSC 2] knob to adjust the volume of oscillator 2.
3
Use the MIXER [NOISE] knob to adjust the volume of the noise generator.
Filter settings
Selecting the routing
1
Use the [ROUTING] button to select the filter rout-
ing.
Each time you press the button, the routing of filters 1
and 2 will change. The LED of the selected routing
will light. You can choose one of four different rout-
ings. If you choose SINGLE, only filter 1 will be used.
Filter 1 settings
1
Use the FILTER 1 [TYPE] knob to select the type of
filter being used by filter 1.
You can adjust the knob to obtain intermediate char-
acters between these filter types. The filter type will
have a major effect on the character of the sound.