Editing
42
3
Use the EG 2 [SUSTAIN] knob to set the sustained volume level.
Turn the knob toward the right (increase the value) to make the sustain volume louder.
4
Use the EG 2 [RELEASE] knob to adjust the time required for the volume to fade away after
you release the key.
Turn the knob toward the right (increase the value) to make the release slower, or turn it toward
the left (decrease the value) to make the release faster.
For bell-type sounds, use a higher setting to create a long release.
Using keyboard dynamics to affect the volume
1
Go to the Program Edit mode P09–2: EG – EG2 tab
page.
2
Use “LvlVelInt” to specify how much the dynamics of
your playing on the keyboard will affect the volume
level change produced by EG2.
With positive (+) settings, the EG2 will produce greater
change in volume as you play more strongly.
With negative (–) settings, the EG2 will produce less
change in volume as you play more strongly.
LFO settings
An LFO (Low Frequency Oscillator) applies a cyclic change to a parameter. This will produce vibrato if ap-
plied to oscillator pitch, a wah effect if applied to filter cutoff, and tremolo if applied to amp level.
LFO2 is internally routed to the pitch of oscillator 1 (P05–1: PITCH page “Vibrato Int”). By making
virtual patch settings you can use the LFO to apply modulation to other parameters as well.
(
p.81 “VibratInt (Vibrato Intensity)”)
Selecting the LFO waveform
1
Press the [SELECT] button.
The waveform will switch each time you press the button, and the
LED of the selected waveform will light.
The shape of the cyclic change will depend on the LFO waveform
you select.
Specifying the LFO frequency
2
Turn the [FREQ] knob.
Turning the knob toward the right (increasing the value) will speed
up the cyclic change. The speed is indicated by the interval at which
the [SELECT] button blinks.
In the P10–1: LFO – LFO1 tab page or LFO2 tab page, you can turn on the “TempoSync” parameter
so that the LFO frequency will synchronize to the tempo specified by the [TEMPO] knob. (
If you want to use the front panel knobs to adjust the LFO “Freq,” use the MOD SEQUENCER [SE-
LECT] button to make the EDIT indicator light.
Summary of Contents for MMT RADIAS
