Kongsberg Simrad MF90, Installation Manual

Page: 290 / 426

288
476671/B
Note
When you work in the
Installation
dialog box, you must always select
Apply
to save the
changes made on a page. You must do this before you continue working on a different page.
Procedure
1 Open the
Setup
menu.
2 On the
Setup
menu, select
Installation
.
Observe that the
Installation
dialog box opens. This dialog box contains a number of
pages selected from the menu on the left side.
3 On the left side of the
Installation
dialog box, select
Sensor Configuration
.
Observe that the
Sensor Configuration
page opens.
4 Select the sensor you wish to configure in the
Sensor
list.
5 If you wish to use the built-in datagram priority, select
Auto
.
• With
Auto
enabled , the priority list is used. Information is imported from the sensor
at the top of the list. If the sensor fails to provide information for more than 20
seconds, data from the next sensor is used.
• With
Auto
disabled , the priority list is not used. Information is imported from the
sensor at the top of the list. All other sensors are ignored.
6 If you wish to control the datagram priority manually, do not select
Auto
.
To change the priority for a given datagram, select it, and change its location on the list
using the arrow buttons.
7 If relevant, add a manual value for the sensor input.
8 At the bottom of the dialog box, select
Apply
to save your settings.
9 Repeat for each sensor interface that you need to set up.
10 Continue your work in the
Installation
dialog box, or select
OK
to close it.
Related topics
Setting to work, page 186
Setting up the interfaces to peripheral devices, page 276
Simrad MF90 Installation Manual