Kongsberg Simrad MF90, Installation Manual

Page: 279 / 426

476671/B
277
Procedure
1 Open the
Setup
menu.
2 On the
Setup
menu, select
Installation
.
Observe that the
Installation
dialog box opens. This dialog box contains a number of
pages selected from the menu on the left side.
3 Set up the interfaces to the navigation sensors.
a On the left side of the
Installation
dialog box, select
I/O Setup
.
b Set up the relevant serial or Ethernet (LAN) communication parameters.
c At the bottom of the page, select
Apply
to save your settings.
d On the left side of the
Installation
dialog box, select
Sensor Installation
.
e Select the type of sensor you want to interface, and define the relevant parameters.
f Select
Add
to save the new sensor interface you have defined.
g On the left side of the
Installation
dialog box, select
Sensor Configuration
.
h Define the priority of the datagrams, and set up relevant configuration parameters.
i At the bottom of the page, select
Apply
to save your settings.
4 Repeat for each sensor interface that you need to set up.
5 Continue your work in the
Installation
dialog box, or select
OK
to close it.
Related topics
Setting to work, page 186
Setting up the interfaces to peripheral devices, page 276
Defining the serial and Ethernet (LAN) port parameters
For any sensor interface to work, the communication parameters must be set up correctly.
The MF90 software automatically scans the Processor Unit to locate and identify the
available communication ports. Once the software has established a list of valid interfaces,
you can set up and control the communication parameters.
Prerequisites
This procedure assumes that:
• You have a vacant interface port on your Processor Unit.
• You are familiar with NMEA and other relevant datagram formats.
Setting to work