Kongsberg Simrad MF90, Installation Manual

Page: 278 / 426

276
476671/B
Setting up the interfaces to peripheral devices
Topics
Installing navigation sensors and other sensors, page 276
Defining the serial and Ethernet (LAN) port parameters, page 277
Setting up the input from a navigation system (GPS), page 279
Setting up the interface for speed log input, page 282
Setting up the interface for course gyro input, page 284
Configuring the sensor interface, page 287
Setting up the input from a motion reference unit (MRU), page 289
Setting up the MF90 system for synchronized operation, page 291
Setting up input from buoys, fish aggregating devices and other external objects, page 294
Installing navigation sensors and other sensors
For the MF90 system to use and offer correct navigational information, one or more external
sensors must be connected. Typical sensors are those providing navigational information
(heading, speed or geographical position). To set up the communication parameters on the
serial and LAN ports, use the
I/O Setup
page. To select which sensors to install, use the
Sensor Installation
page. The
Sensor Configuration
page allows you to define a datagram
priority, so that the information from the "most reliable" sensor is used by the MF90 system.
You can also define manual values in case a sensor is unserviceable, or not installed.
Prerequisites
The new sensor is physically connected to the MF90 system using a serial or network cable.
Context
The
Sensor Installation
page allows your MF90 system to communicate with external sensors
and systems. However, in order to communicate with each sensor, you must first set up the
relevant communication parameters. Once the communication has been established and the
sensor is connected, you must define the datagram priority and finalize the configuration.
Note
Just making changes and selecting
OK
at the bottom of the page will not install anything.
Select what to install, define the relevant parameters, and then select
Add
.
Simrad MF90 Installation Manual