Kongsberg Simrad MF90, Installation Manual

Page: 296 / 426

294
476671/B
In Slave mode, the MF90 system waits for the delay time after the external trigger
signal has arrived before transmitting the ping. This is often referred to as a
post-trigger .
8 From the list of ports available, select
Synchronization Port
.
This is the interface port currently used to transmit or receive synchronization signals.
It must be an RS-232 serial port. Since the synchronization function only uses the
Request To Send (RTS) and Clear To Send (CTS) signals on a serial port, you may be
able to use a port that is already assigned other interface purposes. For the same reason,
you do not need to define any baud rate.
9 At the bottom of the page, select
Apply
to save your settings.
10 Continue your work in the
Installation
dialog box, or select
OK
to close it.
Related topics
Setting to work, page 186
Setting up the interfaces to peripheral devices, page 276
Setting up input from buoys, fish aggregating devices and
other external objects
Position information from external objects such as buoys, fish aggregating devices and other
similar items can be imported into the MF90 system.
Prerequisites
This procedure assumes that:
• You have a vacant interface port on your Processor Unit.
• A suitable receiver system must be available.
• You are familiar with NMEA and other relevant datagram formats.
• You know how to set up the parameters for serial and local area network (LAN)
communication.
• The interface port is set up with the correct communication parameters.
• The MF90 system is turned on and operates normally.
Context
The
Sensor Installation
page allows your MF90 system to communicate with external
sensors and systems. You must specify which communication port to use (LAN (Local Area
Network) or serial port). You can type a custom name to identify the sensor import. In the
list of valid datagram formats, select the format(s) to be accepted by the MF90 system. For
Simrad MF90 Installation Manual