Kongsberg Simrad MF90, Installation Manual

Page: 114 / 426

112
476671/B
The second type of hull unit available for the MF90 system is packed in a similar manner.
A Lifting eye on the gantry
B Support hardware (wooden cradle and support construction)
C Transducer protection (thick foam)
Procedure
1 Remove the top cover of the wooden transport box.
2 Pull out all the nails marked with Indian ink.
3 Remove the wooden cradle and the other supporting
beams.
If you wish to reuse the transport box, make sure to
keep all the support hardware.
4 Fasten the lifting tackle to the two lifting eye bolts
on either side of the top of the gantry.
5 Lift the hull unit ( with the transducer protection still
in place! ) carefully out of the transport box.
Note
Make sure that you use the correct lifting eye! There are two lifting eyes on each side
of the hull unit. One is located on the top of the gantry, and one on the top of the
transducer shaft. Make sure that you use the lifting eyes on the gantry!
6 Make sure that you do not damage the delicate parts of the hull unit.
Note
Make sure that you do not damage the transducer or any of the cables. Watch the hull
unit carefully during the lift to prevent the delicate parts from being damaged, stuck or
hooked on to protruding objects. Do not remove the transducer protection (the thick
foam) until just before the hull unit is lowered onto the installation trunk.
Simrad MF90 Installation Manual