Kodak 8342693 - Capture Software - PC, User Manual

Page: 344 / 412

9C-2 A-63054 February 2004
3. Select the Color resolution , Grayscale resolution , and/or Bi-tonal
resolution from the drop-down list(s).
Valid resolutions are 75, 100, 150, 200, 240, 300, 400, and 600 dpi.
NOTES: To achieve the best possible throughput when scanning at
300 dpi or higher, it is highly recommended that you upgrade
the i250/i260 Scanner memory from 64 MB to 256 MB. The i280
Scanner comes standard with 256 MB of memory. Refer to the
Kodak
i200 Series Scanners User’s Guide for information about installing
memory.
When bitonal-only scanning, the color and grayscale image resolution
settings are not available.
When color-only or grayscale-only scanning, the bitonal image
resolution setting is not available.
When color scanning, the grayscale resolution setting is not available.
Similarly, when grayscale scanning, the color resolution setting is not
available.
When dual-stream scanning, (e.g., color and bitonal at the same
time), all combinations of all resolutions are valid. However, the
scanner transport will run at a speed that is based on the highest
resolution setting. The higher the resolution setting, the slower the
transport speed.
IMPORTANT: When color-only or grayscale-only scanning, Capture Software
“behind the scenes” will still scan in dual-stream using the
grayed-out bitonal Page and Image settings. The bitonal
images will never be displayed or stored to disk, but they will be
used as necessary for patch code reading, bar code reading,
etc. As a result, the grayed-out bitonal resolution may dictate
the speed at which the scanner runs. For instance, if the color
resolution is set to 100 dpi, but the grayed out bitonal resolution
is set to 300 dpi, the scanner will run at a slower transport
speed due to the 300 dpi bitonal setting.
4. Select a multi-feed detection option from the Ultrasonic multi-feed
detection drop-down list.
Choose from either None, Warn, or Warn and Stop.
When enabled, the scanner warns you with an audible alarm whenever a
multi-feed is detected (commonly caused by two or more pages stuck
together as they pass through the feeder). The scanner remains enabled
and continues to scan.
When Warn and Stop is selected, the scanner feeder and transport stop
immediately when a multi-feed is detected. You must open the scanner
and remove the multi-feed sheets, then restart the scanner from Capture
Software before you can resume scanning.
5. When Ultrasonic multi-feed detection is enabled, select a multi-feed
sensitivity from the Sensitivity drop-down list.
Choose from either Low, Medium, or High. Select High when scanning
thinner documents for more frequent occurrences of multi-feeds.
Select Low when scanning thicker documents for less frequent
occurrences of multi-feeds.