A-63054 February 2004
9C-11
Auto delete images
—allows you to discard images below or above a byte
threshold during scanning. This is useful for automatically removing blank rear
sides. The Auto-delete check is performed after any fine cropping, splitting, or
merging that may take place.
NOTES: When dual-stream scanning, it is recommended that you
define separate image setups for color, grayscale, and bitonal
when auto-deleting images. This is because the byte threshold
for blank bitonal images is much different from blank color and
grayscale images.
A byte threshold of up to 1,000,000 bytes may be specified for blank
color and grayscale images.
The auto-delete images option is not available for Capture Software
Lite
for i200 Series Scanners.
Mask tab
Mask coordinates define the area to be scanned. Each image (Front Bi-tonal,
Rear Bi-tonal, Front Color, Rear Color) can have its own unique scan area.
The Mask tab is only available when the Page Setup is defined for Fixed
Cropping (i.e., scanner auto-crop is disabled) or Relative Cropping (also
known as Zone Processing). When Fixed Cropping, the mask coordinates are
measured relative to the top left corner of the scanner transport. When
scanning using the platen (flatbed), the mask coordinates are measured
relative to the reference arrow on the platen. When Relative Cropping, the
mask coordinates are measured relative to the top left corner of the scanned
document.
The Scan Mask can either be manually keyed in or defined using the
Draw
function.
To define a Scan Mask manually:
1. Specify the
Left
value.
2. Specify the
Top
value.
3. Specify the
Width
value.
The maximum width value is 12 inches (coordinate value: 1200).
Summary of Contents for 8342693 - Capture Software - PC
Page 1: ...Capture Software User s Guide A 63054...
Page 3: ......
