9B-8
A-63054 February 2004
Auto delete images
—allows you to discard images below or above a byte
threshold during scanning. This is useful for automatically removing blank
sides (e.g., blank rears). The Auto-delete check is performed after any auto-
cropping, splitting, or merging that may take place.
NOTES: When enabled, auto-deletion will take place on all scanned images
(front and rear). This is different from the way auto-deletion works
with other Kodak scanners, where you can specify a different auto-
deletion setting for each side of a scanned page.
Auto-deletion is not available for Capture Software
Lite
for
i50/i60/i80 Scanners.
Mask tab
Mask coordinates define the area to be scanned. Values are expressed in
hundredths of an inch. By default, Capture Software comes with pre-defined
image settings for A4- and letter-size documents for both automatic document
feeder and flatbed scanning.
Draw mask
—opens a scan window. Scan one page and draw a mask on the
image and click OK. Capture Software automatically calculates the mask
parameters and enters the value in the Left, Top, Width, and Height fields.
Depending on whether you are setting up the front or rear image, Capture
Software displays the image coming from the front or rear scanner.
NOTE: The
Left
field value you use will be different depending on whether you
are scanning with the feeder or the flatbed. When scanning from the
flatbed, documents are usually placed in the upper left corner of the
flatbed platen—the (0, 0) point. Therefore, the Left value will usually be
“0.” However, when scanning from the feeder where documents are
center-fed, the Left value must be adjusted based on the distance of
the document from the left side of the feeder transport.
• The maximum
Width
value is 8.5 in.
• The minimum
Height
value is 14 in. (14.27 in. for the i80 Scanner) for
feeder scanning and 11.7 in. for flatbed scanning.
• If a value greater than 11.7 in. is specified when flatbed scanning, Capture
Software automatically adjusts the setting to 11.7 in. prior to scanning.
• The combined values of the Left and Width fields should not exceed the
scanner’s maximum width of 8.5 in.
• The combined values of the Top and Height fields should not exceed the
scanner’s maximum height of 14 in. (14.27 in. for the i80 Scanner).
Summary of Contents for 8342693 - Capture Software - PC
Page 1: ...Capture Software User s Guide A 63054...
Page 3: ......
