Keysight Technologies N5171B EXG, User Manual

Page: 23 / 473

Keysight EXG and MXG X-Series Signal Generators User’s Guide 7
Signal Generator Overview
Front Panel Overview
11. Preset and User Preset
These hardkeys set the signal generator to a known state (factory or user–defined). See “Presetting
the Signal Generator” on page 40 .
12. RF Output (N5171B, N5172B, N5181B, N5182B)
12. RF Output (N5173B, N5183B)
13. RF On/Off and LED
This hardkey toggles the operating state of the RF signal present at the RF OUTPUT connector. The
RF On/Off LED lights when RF output is enabled.
14. Mod On/Off and LED
This hardkey enables or disables the modulation of the output carrier signal by an active
modulation format. This hardkey does not set up or activate a format (see “Modulating the Carrier
Signal” on page 54 ).
The
MOD ON/OFF
LED lights when modulation of the output is enabled.
15. Page Down
In a table editor, use this hardkey to display the next page. See “Example: Using a Table Editor” on
page 42 . When text does not fit on one page in the display area, use this key in conjunction with the
Page Up key ( page 6 ) to scroll text.
16. I Input (vector models only)
See also, “I/Q Modulation” on page 245 .
Connector Standard:
Option 1EM:
Impedance:
female Type–N
Rear panel output
50 Ω
Damage Levels 50 Vdc, 2 W maximum RF power
Connector Option 513/520:
Option 532/540:
Option 1ED Option
1EM:
Impedance:
male Precision APC-3.5
male Precision 2.4 mm
female Type–N
Rear panel output
50
Ω
Damage Levels 0 Vdc, 0.5 W maximum RF power
Connector Type: female BNC Impedance: 50
Ω
Signal An externally supplied analog, in–phase component of I/Q modulation.
The signal level is = 0.5 V
rms
for a calibrated output level.
Damage Levels 1 V
rms