Juniper SRX 5800, Hardware Manual

Page: 50 / 536

Table 14: Standard Capacity AC Power Supply LEDs
Description State Color Label
AC power applied to power supply is not within the normal operating
range.
Off Green AC OK
AC power applied to power supply is within the normal operating range. On
DC power outputs generated by the power supply are not within the
normal operating ranges.
Off Green DC OK
DC power outputs generated by the power supply are within the normal
operating ranges.
On
Power supply is functioning normally. Off Red PS FAIL
Power supply is not functioning normally. Check AC OK and DC OK LEDs
for more information.
On
SRX5800 Services Gateway High-Capacity AC Power Supply
High-capacity AC power supplies provide a maximum of 4100 W of power each. Two high-capacity power
supplies are required, and you can install four high-capacity power supplies for redundancy. Each
high-capacity AC power supply has two corresponding AC appliance inlets: one located in the chassis
directly above the power supply and one located near the top edge of the power supply itself. For each
power supply, you connect one power cord to the inlet on the chassis above the power supply and one
power cord to the inlet on the power supply itself. Each inlet you connect requires a dedicated AC power
feed and a dedicated 15 A (250 VAC) circuit breaker. See Figure 17 on page 53 .
NOTE: The services gateway cannot be powered from standard-capacity and high-capacity AC
power supplies simultaneously. The one exception is during the process of replacing
standard-capacity AC power supplies with high-capacity AC power supplies, when it is permissible
to have both types installed briefly.
51