Juniper SRX 5800, Hardware Manual

Page: 356 / 536

9. Place one hand around the front of the port module and the other hand under it to support it. Slide
the port module completely out of the Flex IOC, and place it on the antistatic mat or in the electrostatic
bag.
Figure 140: Removing a Port Module
g030282
10. If you are not reinstalling a port module into the empty slot within a short time, install a blank panel
over the slot to maintain proper airflow in the card cage.
CAUTION: After removing a port module from the chassis, wait at least 30
seconds before reinserting it, removing a port module from a different slot, or
inserting a port module into a different slot.
Installing an SRX5800 Services Gateway Port Module
Before you begin to install a port module:
•
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See “Prevention of
Electrostatic Discharge Damage” on page 505 .
Ensure that you have the following available:
357