Juniper SRX 5800, Hardware Manual

Page: 274 / 536

•
ESD grounding strap
To remove the air filter (see Figure 118 on page 275 ):
1. Attach an ESD grounding strap to your bare wrist, and connect the strap to one of the ESD points on
the chassis.
2. Unwrap any cables on the cable manager and remove the cables from the tray. Arrange the cables so
that they do not block the front of the cable manager and tray, and secure them with temporary
fasteners so that they are not supporting their own weight as they hang from the connector.
CAUTION: Do not let fiber-optic cables hang free from the connector. Do not
allow the fastened loops of a cable to dangle, which stresses the cable at the
fastening point.
3. Simultaneously pull the two releases labeled PULL on the cable manager. Lift it up and outward to lock
it in place to access the air filter.
4. Slide the air filter tray out of the chassis.
5. Lift the air filter out of the air filter tray.
Figure 118: Removing the Air Filter (Standard-Capacity Filter Tray Shown, High-Capacity Similar)
Installing the SRX5800 Services Gateway Air Filter
You should change the air filter every six months.
Before you begin to install the air filter:
•
Ensure you understand how to prevent electrostatic discharge (ESD) damage. See “Prevention of
Electrostatic Discharge Damage” on page 505 .
Ensure that you have the following available:
275