Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Command Reference Manual

Page: 652 / 1506

exclude-prefix
Syntax
[ no ] exclude-prefix Ipv6Prefix [ endIpv6prefix ]
Release Information
Command introduced in JUNOSe Release 10.1.0.
Description
Specifies the IPv6 prefix or range of prefixes to exclude from being allocated to the
requesting router. You can exclude those prefixes that have been assigned to local
interfaces from being delegated to the DHCPv6 clients. The
no version removes the
IPv6 prefix or prefix range from the exclusion set and makes it available again for
delegation to clients.
NOTE: If you attempt to exclude a prefix range that overlaps with another prefix
range that has been already excluded from delegation to clients in the IPv6 local
address pool, an error message is displayed and the configuration fails.
Options
Ipv6Prefix —IPv6 prefix or the starting IPv6 prefix of the range of prefixes to be
excluded from being delegated to the requesting router.
■
■
endIpv6Prefix —Ending prefix of the range of IPv6 prefixes to be excluded from
being delegated to the requesting router. If you specify this value, all prefixes
from the starting IPv6 prefix up to this prefix are excluded from allocation.
Mode
IPv6 Local Pool Configuration
610 ■
exclude-prefix
JUNOSe 11.1.x Command Reference Guide A to M