Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Command Reference Manual

Page: 946 / 1506

ip pim rp-candidate
Syntax
ip pim rp-candidate interfaceType interfaceSpecifier [ group-list accessListName ]
[ hold-time holdTime ] [ priority priority ] [ interval interval ]
no ip pim rp-candidate interfaceType interfaceSpecifier
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Defines a router as a rendezvous point (RP) router candidate. The no version stops
the router from being an RP candidate.
Options
■
interfaceType —Interface type; see Interface Types and Specifiers on page 5
■
interfaceSpecifier— Particular interface; format varies according to interface type;
see “Interface Types and Specifiers” on page 5. The autoRP announcement
messages will contain the IP address for this interface.
■
accessListName —Access list containing the set of group prefixes supported by
this C-RP. If no group-list is specified, the default value is the entire multicast
address range.
■
holdTime —Amount of time in the range 1–65535 seconds that the BSR keeps
an RP in its C-RP list if the BSR does not receive a C-RP advertisement message;
default value is 150 seconds
■
priority —Priority field value in the range 0–255 that the C-RP sends to the BSR
in C-RP advertisement messages. In the RP election process, the RP with the
lower priority value is preferred; default value is 192
■
interval —Interval in the range 1–65535 seconds at which the C-RP sends
advertisement messages to the BSR; default value is 60 seconds
Mode
Global Configuration
904 ■
ip pim rp-candidate
JUNOSe 11.1.x Command Reference Guide A to M