Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Command Reference Manual

Page: 1058 / 1506

ipv6 address
Syntax
[ no ] ipv6 address ipv6Prefix [ eui-64 ]
[ no ] ipv6 address [ ipv6Address maskLength [ eui-64 ] ]
Release Information
Command introduced before JUNOSe Release 7.1.0.
Description
Assigns an IPv6 address (or network) to an interface and enables IPv6 processing
on that interface. The
no version deletes the association from the interface.
NOTE: The link-local address for an interface is automatically configured when IPv6
is enabled on the interface.
Options
ipv6Prefix —Prefix that defines the IPv6 interface or network in the format
ipv6Address / length , where
■
■
ipv6Address— Base IPv6 address of the network route that you want to filter
(for example, ::ffff:a:b:c:d)
■
length —Length of the network prefix; number of bits masking base address
to produce address to be matched
■
ipv6Address— Base IPv6 address of the network route that you want to filter (for
example, ::ffff:a:b:c:d); the ipv6Address must appear in hexadecimal format using
16-bit values between colons. Refer to RFC 2373—IP Version 6 Addressing
Architecture (July 1998) for details.
■
maskLength —Length of the IPv6 mask. A decimal value that indicates how many
of the high-order contiguous bits of the address comprise the prefix (the network
portion of the address).
■
eui-64—Specifies the use of the eui-64 interface identifier
Mode
Interface Configuration, Profile Configuration
1016 ■
ipv6 address
JUNOSe 11.1.x Command Reference Guide A to M