Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Command Reference Manual

Page: 1024 / 1506

ip vrrp icr-partition svlan-range
Syntax
ip vrrp vrid icr-partition svlan-range [ svlanIdStart svlanIdEnd ]
[ use-default-mac ] [ control-interface ] [ advertise-mac ]
no ip vrrp vrid icr-partition svlan-range [ svlanIdStart svlanIdEnd ]
Release Information
Command introduced in JUNOSe Release 10.3.0.
Description
Adds a range of S-VLANs to the ICR partition. You can only assign unique S-VLANs
to the partition. If you attempt to assign a previously assigned S-VLAN range to the
ICR partition, the router displays an error message. You can assign S-VLANs only if
you have selected S-VLAN based grouping by using the
ip vrrp icr-partition group
command. The no version deletes the S-VLAN range from the ICR partition.
NOTE: You can use the listed optional parameters only when you add a S-VLAN or
a range of S-VLANs to the ICR partition. You cannot modify an existing subinterface
using these parameters. You can specify the optional parameters in any order.
Options
■
vrid —VRID identifier; a number in the range 1–255
■
svlanIdStart —Starting S-VLAN ID of the S-VLAN subrange you are configuring; a
number in the range 0–4095
■
svlanIdEnd —Ending S-VLAN ID of the S-VLAN subrange you are configuring; a
number in the range 0–4095
■
use-default-mac —Configures the S-VLAN range to use the default MAC address.
By default, the router assigns the VRRP MAC address to all subinterfaces of the
ICR partition.
■
control-interface —Controls traffic on a range of subinterfaces that are part of
a backup partition. When you use this option, the router changes the state of
the corresponding range of subinterfaces to Admindown. When the subinterfaces
are in Admindown state, the router blocks all traffic to the interfaces. However,
the router does not block advertisements as long as VRRP is running on a separate
subinterface. The router changes the state of the range of subinterfaces from
Admindown to Up when the state of the partition changes from backup to master.
■
advertise-mac —Enables subinterfaces to transmit GARP advertisements when
the partition moves from backup state to master state. By default, GARP
advertisements are blocked on subinterfaces.
Mode
Interface Configuration, Subinterface Configuration
Related Topics
Grouping ICR Subscribers Based on S-VLAN IDs
■
■
Configuring an ICR Partition
982 ■
ip vrrp icr-partition svlan-range
JUNOSe 11.1.x Command Reference Guide A to M