Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Command Reference Manual

Page: 751 / 1506

inarp
Syntax
inarp [ frequency ]
no inarp
Release Information
Command introduced in JUNOSe Release 7.1.0.
ATM VC Class Configuration mode added in JUNOSe Release 7.3.0.
Description
In ATM VC Configuration mode, enables Inverse ARP (InARP) on an ATM PVC that
resides on an ATM 1483 NBMA subinterface. Optionally, you can specify the InARP
refresh rate. The
inarp command is valid only for data PVCs configured with aal5snap
encapsulation; you cannot use this command for data PVCs with other encapsulation
types or for control (ILMI or signaling) PVCs. The
no version restores the default
behavior, which disables InARP.
In ATM VC Class Configuration mode, enables InARP as part of a VC class definition
that you assign to an ATM data PVC. The
no version restores the default behavior,
which disables InARP, in the VC class.
Options
■
frequency —InARP refresh rate in minutes, in the range 1–60; default value is 15
Mode
ATM VC Configuration, ATM VC Class Configuration
inarp
■ 709
Chapter 10: I Commands