Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010, Command Reference Manual

Page: 1392 / 1506

mpls l2transport load-balancing-group
Syntax
mpls l2transport load-balancing-group groupNumber
[ mpls-relay remoteIpAddress | route interface tunnel lspName ]
[ vc-id ] vcIdValue [ group-id groupIdValue ]
[ control-word | no-control-word ] [ sequencing | no-sequencing ]
[ relay-format { ethernet | ppp | vlan } ]
no mpls l2transport load-balancing-group groupNumber
{ mpls-relay remoteIpAddress | route interface tunnel lspName } [ vc-id ] vcId
Release Information
Command introduced before JUNOSe Release 7.1.0.
control-word , no-control-word , sequencing , and no-sequencing keywords added
in JUNOSe Release 7.1.0.
Description
Specifies a Martini layer 2 transport circuit, associates it with a load-balancing group,
and accesses L2 Transport Load-Balancing-Circuit Configuration mode. The
no version
removes a circuit from the load-balancing group and all subinterfaces that the circuit
was configured on.
Options
NOTE: Using the mpls-relay keywords has the same effect as using the mpls-relay
command. Using the route interface keywords has the same effect as using the
route interface commands. The relay-format frame-relay option is not supported
for the mpls l2transport load-balancing-group command.
■
groupNumber —Integer in the range 1–127
■
remoteIpAddress —IP address of the router on the remote end of the layer 2 circuit
■
lspName —Name of the route interface tunnel
■
vcidValue —Integer in the range 1–4294967295 that identifies the virtual
connection; the two ends across the MPLS core must match inside each VC type
■
groupIdValue —Integer in the range 0–4294967295 that identifies a group of
virtual connections; not currently used
■
control-word—Indicates that the local preference is to use the control word for
the layer 2 packets encapsulated in MPLS packets sent to the remote PE router.
The default preference is determined by the interface stack on which the MPLS
interface is stacked.
■
no-control-word—Indicates that the local preference is to not use the control
word for the layer 2 packets encapsulated in MPLS packets sent to the remote
PE router. The default preference is determined by the interface stack on which
the MPLS interface is stacked.
■
sequencing—Specifies that the local preference is to include nonzero sequence
numbers with the control word; enabling the remote PE to detect out-of-order
packets; has no effect if no control word is sent in the packets. The router always
accepts zero sequence numbers and checks the order of nonzero sequence
1350 ■
mpls l2transport load-balancing-group
JUNOSe 11.1.x Command Reference Guide A to M